TESCOM減壓閥 調節器44-2263應該如何調節

TESCOM減壓閥 調節器44-2263應該如何調節 

減壓閥調大小有以下幾步：

第步：關閉減壓閥前的閘閥，開啟減壓閥后的閘閥，制造下游低壓環境；

第二步：將調節螺釘逆時針旋轉至最上位置（相對最低出口壓力），然后關閉減壓閥后閘閥；

第三步：慢慢開啟減壓閥前的閘閥至全開；

第四步：順時針慢慢旋轉調節螺釘，將出口壓力調至所需要的壓力（以閥后表壓為準）；

第五步：調整好后，將螺母鎖緊，打開減壓閥后閘閥；

注意：由于減壓閥的工作原理設定，因此如在調整時出口壓力高于設定壓力，須從開始重新調整，即只能從低壓向高壓調。

How to adjust the TESCOM pressure reducing valve regulator 44-

2263

How to adjust the TESCOM pressure reducing valve regulator 44-

2263

There are several steps to adjust the size of the pressure reducing

valve:

Step: Close the gate valve in front of the pressure reducing valve,

open the gate valve behind the pressure reducing valve, and create

a downstream low-pressure environment;

Step 2: Turn the adjustment screw counterclockwise to the highest

position (relative to the lowest outlet pressure), and then close the

yunlian technology  inquiry and quotation  [email protected]

云聯電氣 技術支持 報價[email protected]